======================================================================
96/06/25

This information is gleaned from several sources.  One is a photocopy
of a fax of a magazine article in German from 1993.  Another is a copy
of the product information for the Panasonic AG-1960 5-pin protocol.

I have (not real clear) tiff copies of these pages available if you
want me to email them to you.  If anybody cares to scan the TIFF files
in and convert them to text I'd love to have a copy.  Text much
smaller files.

The TIFF files are:

AG1960_1.TIF   Pages 1 through 11 of a Panasonic product information
.                  bulletin on the AG-1960 5 Pin Protocol.
.              The original photocopies were faxed to my PC
AG1960_B.TIF       and converted to Huffman compressed TIFF files.

CONTROLM.TXT  - This file

CTL_MTXT.TIF  - a faxed copy of the email from which much of this
                    text is typed.
CTL_M_G1.TIF  - a faxed copy of a page from a German Magazine.
CTL_M_G2.TIF  _ a faxed copy of another page from the same article.

The information has been typed in quickly.  Please don't flame me for
any errors, just let me know so I can correct future versions.

David Meed          dmeed@nbnet.nb.ca
======================================================================


                    ============================
                    Panasonic 5 pin edit control
                    ============================

  Remote Control Jack (2.5 mm)
  ----------------------------

    Tip - negative-going TTL pulse synchronous to vertical frame at 100
          Hz (PAL) or 120 Hz (NTSC)

    Ring - +5 on record, frame frequency (25/30Hz at playback)

    Pull TIP to ground briefly to start recording.

  5 pin Edit jack (11 pin jack is a superset of this)
  ---------------------------------------------------

    Synchronous serial transmission clocked by the VTR
    1 bit=27 microseconds
    Bits from VTR become valid at the falling edge of the clock.
    Bits should be sampled at the rising edge of the clock, VTR does this.

    1 Frame = 7 bytes
    Bytes 1 and 2 are all ones (reserved)
    Byte 3 takes commands to the VTR
           VTR Commands
           ==========================
           Send on Byte 3             EC100 EC200 EC300

             $00     Stop                x    x    x
             $02     Rewind              x    x    x
             $03     Fast Forward        x    x    x
             $04     Review              x    x    x
             $05     Cue                 x    x    x
             $06     Still/pause         x    x    x
             $08     Record              x    x    x
             $09     A-Dub               x
             $0A     Play                x    x    x
             $0B     Reverse Play             x    x
             $0C     Frame Advance       x    x    x
             $0D     Reverse Frame Adv.       x    x
             $0F     Slow                x
             $2E     Slow Up             x
             $2F     Slow Down           x
             $33     Counter Reset       x    x    x
             $94     Direct Search       x
             $9D     Assemble Insert     x    x    x
             $9E     Assemble Record     x    x    x
             $9F     Assemble Play       x    x    x
             $A8     Preroll Wait                  x
             $A9     Assemble A-Dub           x    x
             $AA     Assemble A/V Insert      x    x
             $AB     Rehearsal A-Dub          x    x
             $AB     Rehearsal A/V Insert     x    x       ?? $AC ??
             $AB     Rehearsal Insert         x    x       ?? $AD ??
             $AB     Rehearsal Record         x    x       ?? $AE ??
             $AF     Frame Requeset           x    x
             $EF     NOP (Connect)       x
             $FE     NOP                      x    x
           ==========================

    Byte 4...7 are data from the VCR
         4 - state of drive mechanism
          VTR Modes
           ==========================
           Recieve Byte 4, Low 4 bits

             $0      Stop
             $1      Eject
             $2      Rewind
             $3      Fast Forward
             $4      Review
             $5      Cue
             $6      Slow
             $7      Power Off
             $8      Play
             $9      Still/Pause
             $A      Record
             $B      Record Pause
             $C      Audio Dub
             $D      Audio Dub Pause
             $E      Insert
             $F      Insert Pause
           ==========================

    Byte 5 - unit of time/hi digit of tape position
      Byte 5                        Byte 6, 7
      ============================================================
      %0000xxxx - Tape counter      Count Hi 2 digits, Lo 2 digits
      %0101xxxx - Memory counter    Count Hi 2 digits, Lo 2 digits
      %x01xnnnn - Hour * 1 digit    Minutes, Seconds
      %x11xnnnn - Minute * 1 digit  Seconds, Frames
      ============================================================

      Series VW-EC300 Cameras
      ============================================================
      Byte 5 bit 4  (& %00010000) - counter sign, 1=negative
      Byte 5 bit 7  (& %10000000) - reverse play mode, 1=reverse
      ============================================================



Timing diagrams  (ASCII Art - use a monospaced font to view!)
===================================================================
      _      _                 _      _
    _/ \____/ \  /\          _/ \____/ \  /\
   /           \/  \        /           \/  \
  ------------------------ ----------------------    Video signal
                          -                      -

  <--------ca 20ms (PAL)---->   (16.6ms NTSC)
  <ca 4ms>
          ___________________        ____________    Synchronized to
  ||||||||                   ||||||||                video signal

  |       \
  |         \
  |           \
  |             \
  |               \
  min 600 us  <---> between bytes
        216 us<->   each byte
  _ ___ ___ ___ ___ ___ ___ ___ ______     Clock
  |_| |_| |_| |_| |_| |_| |_| |_|

  _1___2___3___4___5___6___7___8______     Data Byte
  |_| |_| |_| |_| |_| |_| |_| |_|
             /   \
   1 & 2 Reserved  \
          /3 - Data to VCR
        /      4,  5,  6,  7,  8 - Data from VCR
      /                 \
    /                     \
  /                         \
  _   _   _   _   _   _   _   _   ________
   |_| |_| |_| |_| |_| |_| |_| |_|          Clock

  __   _________   _____   _____   ________
   |___|       |___|   |___|   |___|        Data (Bits)
     0   1   1   0   1   0   1   0
    MSB                         LSB
   <---> 27us
                                               __
    Bits become valid with clock falling edge    |__
                                                  __
         and are sampled at clock rising edge  __|

===================================================================


Panasonic 5 pin and 11 pin connector
===================================================================


               (key)                        (Key)
                 |                            |
                 v                       11   v   6
              5     1                      5     1

             4       2                 10 4       2 7
                 3                            3
                                           9     8


                                        (only 11 pin)
     Pin 1 - CR power Switch            Pin  6 - Audio out L
     Pin 2 - Serial Data                Pin  7 - Audio Gnd
     Pin 3 - Gnd                        Pin  8 - Audio out R
     Pin 4 - Serial Clock               Pin  9 - Chroma
     Pin 5 - +5 regulated               Pin 10 - Video Gnd
                                        Pin 11 - Luminance
===================================================================
